COPYING BOTH SIDES OF A CARD AS A SINGLE PAGE (CARD SHOT)

Overview

This function copies the front and reverse sides of a card on one sheet.
This function is convenient for making copies for identification purposes.

To change the default original size during Card Shot:
In "Setting mode (administrator)", select [System Settings] → [Copy Function Settings] (Tab) → [Copy Function Settings] → [Card Shot Settings].

Operation

  1. 2

    Select the paper to be used for card shot

  2. 2

    Tap the [Others] key, and tap the [Card Shot] key

  3. 2

    Tap the [On] key, and specify the original size

    After the settings are completed, tap icon and the [Back] key in sequence.

    • Tap the areas displaying width and height sizes of the original respectively, and enter the sizes using the numeric keys.
      Or tap icon to enter the width and height sizes.
    • When you set the [Adjust to Paper Size] checkbox to , the original is enlarged or reduced by the ratio appropriate to the original size.
    To cancel the Card Shot settings:
    Tap the [Off] key.
  4. 2

    Place a card face down on the document glass, and tap the [Preview] key

  5. 2

    Place a card face up on the document glass, and tap the [Additionally Scan] key to scan the reverse side

    Copy settings cannot be changed when scanning additional pages.
  6. 2

    Check the preview image in the preview screen

    To cancel all settings:
    Tap the [CA] key.
  7. 2

    Tap the [Start] key to start copying

    To make two or more sets of copies:
    Tap the copies display key to specify the number of copies.
Back to top