PUNCH MODULE (MX-PNX4B)

Overview

The punch module can be installed on a finisher (50-sheet stapling) or saddle finisher (50-sheet stapling) to punch holes in paper to be output.
A finisher (50-sheet stapling) or saddle finisher (50-sheet stapling) is required to install the punch module.

Discarding punch waste

Punch waste from punched holes is collected in the punch waste box.
Follow the operation procedure to replace punch waste.

  1. Open the cover

  2. Gently pull out the punch waste box and discard the punch waste

    Discard the punch waste in a plastic bag or other container, taking care not to let the waste scatter.

  3. Replace the punch waste box

    Make sure the punch waste box is replaced correctly.

  4. Close the cover

Back to top